iSEMC Support Portal
  • iSEMC Support Home
  • Product Setup
    • Video Wall Controller
      • IP Based
        • NP Pro
          • User Manual
          • Spcification
        • NP-L
          • User Manual
          • Specification
      • VK Series
        • VK-S
          • User Manual
          • Specification
          • API
        • VK-B
          • User Manual
          • Specification
          • API
        • VK-L
          • User Manual
          • Specification
    • LCD Videowall
      • LCD Video Wall
        • User Manual
        • Specifications
      • Interactive Flat Panel
        • Specification
        • User Manual
    • LED Video Wall
      • Fine Pitch Installation Manual Sample
  • Control Room Designer
    • iSEMC Control Room Configuration
    • Configuration Requirements
    • Template
  • HELP
    • Trouble Shooting
      • NP Pro
      • NP Lite
      • VK-S
      • VK-B
      • VK Lite-S
    • Quick Start
      • NP Pro
      • NP Lite
      • VK-S
      • VK-B
      • VK Lite-S
      • LCD Video wall
    • Video Resources
  • FAQS
  • Product FAQ
    • IP Based- FAQ
    • FPGA FAQ
  • Service FAQ
  • Commercial FAQ
  • Contact
    • iSEMC Technical Support
Powered by GitBook
On this page
  • 1.Cannot Connect To The Control Software
  • 2.Input/Output Display Abnormalities

Was this helpful?

  1. HELP
  2. Trouble Shooting

NP Lite

PreviousNP ProNextVK-S

Last updated 3 years ago

Was this helpful?

1.Cannot Connect To The Control Software

-Please check whether the RJ45 interface indicator on the output node or CMS node is working. If it does not work, then the network cable may be abnormal. Please replace the network cable and try again

-The default IP of the controller is 192.168.0.200, so you need to set the control computer and all devices in the controller to the same network segment (input node/output node)

IP address:192.168.0.xx(2~254) Subnet mask:255.255.255.0 Default gateway:192.168.0.1

-If you still cannot connect, please contact iSEMC technical support staff to provide you with remote support

2.Input/Output Display Abnormalities

-Please connect the HDMI cable connected to the normal working input and output node to the abnormal node, and check whether the problem will follow the node to move. If the abnormality does not follow the node, it is likely that the HDMI cable is abnormal. Please replace the cable and try again. If there is still no progress, please contact the iSEMC technical support staff to provide remote support for you.