NP Lite

Np Lite Video Wall Controller Quick Start_V 1.5.4

1. Hardware preparation before commissioning:

l Prepare a PC commissioning terminal that supports 1080P resolution and installs WIN10.

l Np Lite equipment. (Np lite node, HDMI cable, network cable, Gigabit switch with POE function.)

2. Safety check before use:

1. All displays are installed and powered on

2. Whether all HDMI and network cables are connected

3. Whether the POE, Np lite node and others equipment is operating normally

3. Introduction to the device interface

4. Connection diagram

Input node: connect the signal source

Output node: connect to the screen

Input and output node: Input and output node both connect to switch.

Control PC: LAN connection/ network control connection control/ computer network cable.

5. Commissioning software installation and recognition:

5.1 Open the U disk to install the software

5.2 Video wall control system software icon

5.3 Software login interface

Account: admin

Password: admin123

5.4 Enter the software interface

The software is stored with the equipment in the form of a U disk. For specific operations, please refer to the operation manual (the operation manual is stored with the equipment), or consult professional technicians.

6. Computer terminal control can be realized through the network gigabit switch

Modify the computer IP to ensure that it is in the same network segment as the Np Lite device.

Change the Ethernet IP address of the control computer to the same network segment. The default IP address of Np Lite is 192.168.0.xx. You need to modify the IP address of the control computer to 192.168.0.xx. To change the computer, you need to open the "Network Connection" window. Click on the window R, type "register password" in the run box, and then click the Enter key.

In the "Network Connections" window, right-click the adapter for which you want to set a static IP address, and then select the "Properties" command.

In the properties window of the adapter, select "Internet Protocol Version 4 (TCP/IPV4)", and then click the "Properties" button.

After entering the next page, just make the following modifications, and then click "OK" to save.

IP address: 192.168.0.xx (2~254)

Subnet mask: 255.255.255.0

Default gateway: 192.168.0.1

7. Set up

After saving, you can click Np lite Video Wall Control System software. The software user name is admin, password: admin123. After logging in, You will find the software interface. Now need to choose a different option to play.

8. Software operation

8.1. Video control:

Now simply drag and play input signal to the video wall

8.2. Audio control:

If you have multiple audio devices can connect, control and play from this page.

Note: To multiple audio devices set up from the audio control page, please contact our professional technician.

8.3. Environmental control:

Note: To customize and set up the environmental control page, please contact our professional technician.

8.4. Matrix control:

Note: To customize and set up the matrix control page, please contact our professional technician.

9. Trouble Shooting

9.1 Some input signal was not showing in the signal list

* First check the POE cable and input node.

*Check the Encode and decode system of all node and make sure HDMI connect properly.

As shown in the figure:

9.2 The device connection is unsuccessful

*First check whether the device LAN is connected, if the link is connected, check whether the connection is normal.

*After the connection is normal, check whether the device and the computer are in the same network segment.

As shown in the figure:

IP address: 192.168.0.xx (2~254)

Subnet mask: 255.255.255.0

Default gateway: 192.168.0.1

For routine operation, please refer to the operation manual, and contact the professional technician in time if you have any intractable diseases.